Tail SectionStripping Ugly Tail Thing Mods Home Page Flush Mounts
|
||
| Here we are going to construct a solo seat with a tail section. The goal is to have a solo seat that can lock in to replace the stock upholstery whenever deemed necessary. The materials we are utilizing are , stock pan stripped of foam and vinyl. Sheet of 1/8 inch foam core board from frame or craft shop and Elmer's glue. I started with the break in the seat at the rear by adding a back slanted piece of foam core to extend the angle upward. Then began construction of a tail cone built up with more foam core |
 |
|
 |
I also took the liberty of removing the stock "Grab Bar" leaving a gap between the seat pan and the rear tail faring. This I intend to replace with a small flush body piece also constructed of foam core covered with fiberglass cloth and finished with body filler, painted to match. The versatility of the seat pan solo seat is that it an be installed on any EX250. | |
| Foam Core Tail section sub structure | ||